cisco set switch port to vlan

Switch#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#interface GigabitEthernet0/1
Switch(config-if)#switchport mode access
Switch(config-if)#switchport access vlan 2
Switch(config-if)#description “test server”
Switch(config-if)#end
Switch#show running-config interface GigabitEthernet0/1
Building configuration…

Current configuration : 130 bytes
!
interface GigabitEthernet0/1
description test server
switchport access vlan 2
switchport mode access
spanning-tree portfast
end

Switch#show interface GigabitEthernet0/1 switchport
Name: Gi0/1
Switchport: Enabled
Administrative Mode: static access
Operational Mode: down
Administrative Trunking Encapsulation: negotiate
Negotiation of Trunking: Off
Access Mode VLAN: 2 (TEST)
Trunking Native Mode VLAN: 1 (default)
Administrative Native VLAN tagging: enabled
Voice VLAN: none
Administrative private-vlan host-association: none
Administrative private-vlan mapping: none
Administrative private-vlan trunk native VLAN: none
Administrative private-vlan trunk Native VLAN tagging: enabled
Administrative private-vlan trunk encapsulation: dot1q
Administrative private-vlan trunk normal VLANs: none
Administrative private-vlan trunk private VLANs: none
Operational private-vlan: none
Trunking VLANs Enabled: ALL
Pruning VLANs Enabled: 2-1001
Capture Mode Disabled
Capture VLANs Allowed: ALL

Protected: false
Unknown unicast blocked: disabled
Unknown multicast blocked: disabled
Appliance trust: none

Switch#copy running-config startup-config